Updated November 2026

To clean a Delta faucet aerator, you unscrew the small cap at the tip of the spout, rinse out the mesh screen and internal parts, and soak away the mineral scale that causes weak or uneven flow. The whole job usually takes about 10 minutes and needs only household items. Done regularly, it can restore a steady stream and stop the sputtering that often comes from a clogged aerator.

What You Need Before You Start

Gather a few simple supplies so you are not stopping halfway through. Most of the job can be done with the parts you already have in the kitchen.

Shopping for one? See our guide: Delta Faucet Screen Replacement: 7 Best Aerator Screens Compared.

  • A soft cloth or rubber dish towel to protect the finish and cushion the grip
  • White vinegar and a small bowl or cup
  • An old toothbrush for scrubbing
  • Pliers or a non-marring wrench, wrapped in tape or cloth if needed
  • A small plastic bag or container to hold tiny parts

How to Remove and Clean the Delta Aerator

Start by wrapping the towel around the aerator housing at the tip of the spout. Turn the cap counterclockwise by hand first. If it is stuck with mineral deposits, use pliers gently, applying pressure through the cloth so the finish is not scratched.

Once the cap is off, carefully remove the internal parts in the order they come out. Most Delta aerators contain a small screen, a rubber washer and a plastic flow restrictor or insert. Lay them out in sequence so you can reassemble them correctly.

Soak and Scrub the Parts

Place the screen and insert in a cup of white vinegar and let them soak for 30 minutes. Vinegar dissolves calcium and lime scale well. For heavy buildup, soak for two hours or overnight. Then scrub the mesh gently with the toothbrush and rinse under running water until no grit remains.

Flush the Spout

Before reassembling, run the faucet for about 15 seconds with the aerator body off. This clears loose sediment from the water line and prevents it from settling back into the screen.

Reinstalling the Aerator Correctly

Reassemble the parts in the same order you removed them. Make sure the rubber washer sits flat and the screen faces the right direction. Hand-tighten the cap clockwise until snug. Avoid overtightening, since that can crack the plastic components or strip the threads.

Test the Flow

Turn the water on slowly. A clean aerator should produce a smooth, even stream with no spitting. If you still see weak pressure across the whole faucet, the problem may be in the supply lines or the cartridge rather than the aerator. A guide to Leaky Kitchen Faucet Delta: How to Find and Stop the Drip (Step by Step) can help you track down those issues.

Common Mistakes to Avoid

  • Using a metal tool directly on the finish, which can leave scratches or chips
  • Losing the small washer or insert, which can cause leaks or spraying
  • Reinstalling parts in the wrong order or facing the screen backward
  • Skipping the vinegar soak and only rinsing, which leaves mineral scale behind
  • Forcing a stuck cap instead of letting a vinegar soak loosen the buildup first
  • A soft-jaw or cloth-wrapped plier set helps you grip the aerator cap without damaging the finish. View on Amazon
  • A small nylon brush works well for scrubbing mineral deposits from the screen without scratching it. View on Amazon
  • A faucet aerator key is designed to fit the cap and reduce slipping. View on Amazon

FAQ

How often should I clean my Delta faucet aerator?

Most households benefit from cleaning the aerator every three to six months. Homes with hard water may need it more often, especially if you notice a weaker stream.

Can I clean the aerator without removing it?

You can soak the outside of the spout in a bag of vinegar held in place with a rubber band, but this only loosens surface deposits. Removing the aerator gives a far more thorough cleaning.

What if the aerator still has low water pressure after cleaning?

Check whether the problem affects only the kitchen faucet or other fixtures in the home. If it does, the issue may be with the building supply rather than the faucet, and a licensed plumber can help diagnose it.

Conclusion

Cleaning your Delta faucet aerator is a quick job that restores strong, even water flow. Remove the cap, soak and scrub the parts, and reinstall them in order. A few minutes every few months keeps mineral buildup from returning and helps your faucet perform as it should.

Caleb Morgan

About Caleb Morgan

Caleb Morgan is part of our editorial team and reviews and edits our kitchen faucets & sinks guides, checking product details against manufacturer specifications and owner feedback.