Updated November 2026

A dripping Delta faucet is almost always caused by a worn internal part, usually a cartridge, stem, O-ring or valve seat. This guide walks you through identifying which type of Delta faucet you have, shutting off the water safely, and finding the source of the drip so you can fix it without replacing the whole faucet.

Identify Your Faucet Type First

Delta uses several internal designs, and the repair depends on which one you have. Compound-style single-handle faucets, the kind with a long handle that lifts and swings, usually use a ball or cartridge. Older two-handle faucets use compression stems with rubber washers. Many newer single-handle models use a cartridge that screws into the base. If you are unsure, the model number is usually stamped on the base or under the handle cover, and the manual for Delta faucet models is the fastest way to confirm the internal design.

Shopping for one? See our guide: 6 Best Delta Faucet Replacement Parts (2026): Expert Picks.

Shut Off the Water and Prepare

Turn off the water supply valves under the sink before you take anything apart. If the valves are stiff or do not close fully, shut off the main water supply to the house instead. Open the faucet to drain remaining water and place a towel in the sink to protect the finish and keep small parts from falling down the drain.

  1. Close the hot and cold supply valves under the sink.
  2. Open the faucet and leave it on until the water stops.
  3. Pop the decorative cap off the handle and remove the handle screw.
  4. Lift the handle off and note how the parts are arranged.

Find the Source of the Drip

Once the handle is off, you can see the cartridge, stem or ball assembly. A drip from the spout that continues with the handle off usually points to the cartridge or stem. Water leaking around the base of the handle points to the O-rings or the packing nut. Water coming from the spout when the handle is closed and the lever is set to off often means the valve seat is worn or has debris on it.

Symptom Most likely cause
Constant drip from spout Worn cartridge, stem or valve seat
Leak at base of handle Worn O-ring or packing nut
Drip only when hot or cold is on Worn stem washer on that side
Dripping after you shut off Debris on valve seat or misaligned cartridge

Replace the Faulty Part

For most single-handle Delta faucets, replacing the cartridge is the most reliable fix. Remove the retaining clip or nut, pull the cartridge straight up, and take it to a hardware store to match it. Install the new cartridge with the same orientation, apply a light coat of plumber’s grease to the O-rings, and reassemble the handle. For two-handle faucets, replace the stem and washer on the leaking side. Check Replacing a Delta Faucet Cartridge: A Step-by-Step Guide (2026) and Replacing a Delta Faucet Stem: Step-by-Step Fix for Drips (2026) for model-specific details.

If the drip continues after the new part is in, the valve seat may be worn. Some Delta models let you replace the seat with a seat wrench, but this step is more involved. A wider overview of repair options is in Repairing a Delta Faucet: A Step-by-Step Guide for Common Leaks.

Common Mistakes

  • Forgetting to turn off the water before removing parts, which causes spray and flooding.
  • Buying a cartridge by eye instead of matching the model number.
  • Overtightening the handle screw, which can crack the cartridge or handle.
  • Skipping the grease on O-rings, which leads to early leaks.
  • Reassembling the cartridge with the wrong orientation.
  • Plumber’s silicone grease helps seal O-rings and makes cartridges slide in smoothly. View on Amazon
  • A basin wrench reaches the mounting nuts under the sink, which can be hard to access by hand. View on Amazon
  • A cartridge puller removes stubborn cartridges without damaging the faucet body. View on Amazon

FAQ

Why does my Delta faucet keep dripping after I replace the cartridge?

The valve seat may be worn or have mineral debris on it, or the new cartridge may not be fully seated. Check that the cartridge is pushed all the way down and the retaining clip is in place.

Can a dripping faucet waste a lot of water?

Yes. A steady drip can waste a significant amount of water over a month, and it can also stain the sink over time. Fixing it promptly saves water and protects the finish.

When should I call a plumber?

If you cannot identify the faucet type, the valve seat is badly corroded, or the supply valves will not shut off, call a licensed plumber. Water damage from an incorrect repair can be costly to fix.

Conclusion

Most dripping Delta faucets can be fixed in under an hour once you identify the faucet type and the source of the leak. Replacing the cartridge or stem solves the majority of cases. Take your time, keep parts organized, and check the model number before you buy replacements.

Caleb Morgan

About Caleb Morgan

Caleb Morgan is part of our editorial team and reviews and edits our kitchen faucets & sinks guides, checking product details against manufacturer specifications and owner feedback.