Updated November 2026

Most drips and leaks in a Delta two handle bathtub faucet come from a worn cartridge, stem or O-ring. With the water shut off, a few basic tools and a replacement part, you can usually stop the leak in under an hour. This guide walks through diagnosis, disassembly, the fix itself and reassembly.

Before You Start: Identify the Problem

Figure out which handle is leaking before you take anything apart. If water runs from the spout when the handle is off, the valve inside is not sealing. If the leak shows at the handle base or the shower head only switches partly, the stem or cartridge is likely worn. Delta two handle tub faucets commonly use either a compression stem or a cartridge, so check which one you have first.

Shopping for one? See our guide: 5 Best Delta Kitchen Faucet Two Handle Models for Everyday Use (2026).

Repair Steps for a Two Handle Delta Tub Faucet

  1. Shut off the water supply at the access panel or the main valve, then open both handles to drain the lines.
  2. Pry off the decorative handle cap with a flat-blade screwdriver, then remove the handle screw with a Phillips driver.
  3. Lift the handle off the stem. Unscrew the escutcheon or trim sleeve and set it aside.
  4. Remove the packing nut or retaining clip. Pull out the stem or cartridge, noting its orientation.
  5. Replace the cartridge or stem with a matching Delta part, and swap in new O-rings and washers. Lubricate O-rings with plumber’s silicone grease.
  6. Reassemble in reverse order, turn the water back on slowly and test both handles for leaks and smooth operation.

Check the Diverter Too

If water still comes from the spout while you are showering, the tub diverter may be worn. Many Delta tub valves place the diverter behind the trim, so clean or replace it while the valve is open.

Parts and Tools You Will Need

Item Purpose
Matching Delta cartridge or stem Replaces the worn sealing part
Phillips and flat-blade screwdrivers Remove handles and trim
Allen wrench or cartridge puller Pull the stem or cartridge
Plumber’s silicone grease Lubricates O-rings for a tight seal
Soft cloth and towel Protects the finish and catches water

Common Mistakes to Avoid

  • Skipping the water shutoff, which sends water into the wall cavity.
  • Buying a part by appearance alone. Match the model number stamped on the old cartridge or stem.
  • Forgetting to note the cartridge orientation before removing it.
  • Overtightening the packing nut, which can crack the trim or make handles stiff.
  • Scratching the finish with metal tools. Wrap tools in tape or cloth.
  • Silicone plumbing grease helps O-rings seat without tearing and keeps handles turning smoothly. View on Amazon
  • A cartridge puller kit lets you remove a stuck cartridge without damaging the valve body. View on Amazon
  • A faucet O-ring assortment gives you the right sizes on hand when a seal is worn but the cartridge is still good. View on Amazon

FAQ

Can I repair a Delta two handle tub faucet without replacing the whole valve?

Yes. In most cases you only need to replace the cartridge, stem or seals, which costs far less time and effort than a full valve swap.

Why does my tub faucet still drip after I replaced the cartridge?

The new part may be installed backward, or debris may be trapped in the valve body. Reopen the valve, confirm orientation and flush out any grit before reassembling.

When should I call a professional?

If the valve body is cracked, water is leaking inside the wall, or the supply lines are corroded, consult a licensed plumber rather than continuing to disassemble the fixture.

Conclusion

Identifying whether the leak comes from a stem, cartridge or diverter saves time and prevents buying the wrong part. Match the Delta model number, lubricate the seals and reassemble carefully. A patient, methodical repair usually restores a quiet, drip-free tub faucet.

Miles Sinclair

About Miles Sinclair

Miles Sinclair is part of our editorial team and reviews and edits our kitchen faucets & sinks guides, checking product details against manufacturer specifications and owner feedback.