Updated November 2026
To repair a leaking outdoor faucet handle, you shut off the water supply, remove the handle, and replace the worn packing washer or stem cartridge that is letting water seep past the stem. Most fixes take under an hour with basic tools. The steps below cover how to identify the cause, make the repair, and reassemble the faucet so it seals tightly.
Find the Source of the Leak
Before you take anything apart, confirm where the water is escaping. If it drips from the spout when the handle is off, the valve seat or cartridge is the likely culprit. If water seeps out around the handle stem or base while the faucet is running, the packing nut or packing washer is worn. Handle leaks usually point to the packing, which is the most common and easiest repair.
Shopping for one? See our guide: Leaking Outdoor Faucet Repair: 5 Best Kits Compared (2026).
How to Repair the Leaking Handle Step by Step
- Turn off the water at the shutoff valve inside your home, then open the outdoor faucet to drain remaining water.
- Remove the decorative cap or screw holding the handle in place, then lift the handle off the stem.
- Loosen the packing nut with an adjustable wrench and unscrew the stem assembly from the body.
- Pull out the old packing washer or O-ring and note its orientation. Compare it to a replacement of the same size.
- Wrap the threads with plumber’s tape or apply a small amount of silicone plumber’s grease, then fit the new washer.
- Reinstall the stem, tighten the packing nut snugly without overtightening, and reattach the handle.
- Slowly turn the water back on and test the handle with the faucet open and closed.
When the Cartridge Needs Replacing
If the handle still leaks after the packing is replaced, or water drips from the spout when closed, the valve cartridge or seat washer is worn. Replacing these parts follows the same disassembly steps. Take the old part to a hardware store so you match the brand and size, since outdoor faucets come in many configurations. Our guide on How to Repair a Garden Faucet: A Step-by-Step Guide for Leaks and Drips walks through cartridge removal in more detail.
Tools and Supplies Checklist
- Adjustable wrench or basin wrench
- Flathead screwdriver or Phillips screwdriver, depending on the handle screw
- Replacement packing washer or O-rings in the correct size
- Plumber’s tape or silicone plumber’s grease
- A rag or towel to protect the finish
- Replacement cartridge or seat washer if needed
Common Mistakes to Avoid
- Overtightening the packing nut, which can crush the new washer and cause the handle to stiffen or leak again.
- Skipping the water shutoff, which can spray water across the work area.
- Buying a washer by eye instead of measuring the old one, which often leads to a second trip to the store.
- Forgetting to check the hose bib vacuum breaker, since a damaged one can also cause drips.
Recommended Gear
A basin wrench helps reach the packing nut on outdoor faucets mounted close to the wall, where a standard wrench does not fit. A silicone plumber’s grease keeps the new washer seated and reduces friction on the stem. A set of assorted faucet washers covers the common sizes so you can match the old part on the first try.
- Basin wrench for tight spaces behind the faucet: View on Amazon
- Silicone plumber’s grease for washers and O-rings: View on Amazon
- Assorted faucet washer kit for hose bibs: View on Amazon
FAQ
Do I need to replace the whole faucet to fix a leaking handle?
Usually not. Most leaking handles are caused by a worn packing washer or O-ring, which costs little and takes less than an hour to replace. Only a cracked body or severely corroded threads typically justify a full replacement.
Why does my outdoor faucet still drip after I replaced the washer?
The valve seat or cartridge may be worn, or the washer may be the wrong size or installed backward. Remove the stem again and inspect both parts before reassembling.
Can I repair the faucet while it is still connected to the water line?
No. Shut off the supply at the interior valve and drain the line first, or water will continue to flow and spray during the repair. If the shutoff valve is stuck or leaking, consider calling a licensed plumber.
Conclusion
Most leaking outdoor faucet handles come down to a worn packing washer, which you can replace with basic tools in under an hour. Shut off the water, match the old part carefully, and avoid overtightening the packing nut. If the leak returns, check the cartridge or seat washer next.
